I/O CARD

Look at picture of the I/O card.

This COMMANDER I/O function card interfaces 16 digital input signals to a companion Base/Expansion cardfile assembly.

Signals may be either logic common, +DC, or AC in nature, and are fully isolated. Signals greater than 24V require conditioning before presentation to the I/O card input terminal. These inputs can also be used to process low-speed pulsing signals as well as certain encoding signals.

__________________________________________

SPECIFICATIONS

__________________________________________

Functional

• Inputs per card: 16 (sink or source signals; however, source signals required if optional LEDs are to illuminate as intended)
• Commons per card: 2 (group isolated, points 1-8 and 9-16)
• ON voltage: >6.5V
• OFF voltage: <5.5V
• Input impedance: 2.2K
• Input isolation: 5000V (optical coupler)
• Input signal must sink/source 5-10mA
  from 12-24VDC/VAC source. Signals > 24V require external scaling resistor.
• Debounce: 10ms (hardware fixed)
• Terminal types: Removable terminal or IDC (ribbon cable) header as specified

__________________________________________

Operating power

• 10-14VDC input power, from Base assembly
• Typical logic current drain 12mA
• Optional LED indicators draws 3mA each when turned on

__________________________________________

Transient protection

• Meets or exceeds IEEE C37.90A-1987
  surge withstanding specification

__________________________________________

Operating environment (electronics)

• Standard -10 to +70°C temperature
• 0 to 95% relative humidity (non-condensing)

__________________________________________

COMMON INPUT VALUES

Higher voltage levels may be found for indication signals. This is accommodated by adding an external voltage dropping resistor in series with the plus terminal of the card. The nominal resistor values for various voltage levels are:

SIGNAL       R-VAL        ADD'L.       

                          SPECS        



48VDC        6.8K         CC 5% 1/4W   



125VDC       22K          CC 5% 1W     



120VAC       22K          CC 5% 1W     



240VAC       44K          CC 5% 2W     

Use of the Universal Termination Assembly, or equivalent, is recommended when status signals exceed 48V.

__________________________________________

ADDITIONAL INFORMATION

Push the "BACK" button in your browser program after viewing the following pages, to return to this page:

Terminals & Connectors

Look at picture of the I/O card.

__________________________________________

ORDERING INFORMATION

200134: I/O CARD, 16 POINT DI

This assembly is provided in the following versions (XXX designation of part number).

• -000: I/O card, pull-apart termination
• -001: I/O card, pull-apart termination, LED indicators
• -100: I/O card, IDC-type termination
• -101: I/O card, IDC-type termination, LED indicators

200134-000 $209

200134-001 $237

200134-100 $201

200134-101 $229

MATING TERMINALS. Pull-apart Terminal Strips, for versions -000 and -001.
200128-016 $36

200128-002 $6

Go back to I/O Card Introduction

Go back to ADC home page